Publicidad
Idiomas disponibles
Idiomas disponibles
Subwoofer features
Subwoofer back-panel controls
8
9
1
Volume
When you set up your subwoofer for the first time, you may have to make adjustments
control
several times before you hear what you personally like. Start with the volume at 50%. Adjust
by ear using a wide variety of CDs and video sources. Adjust for deep, powerful bass without
"boominess."
We recommend that you use your AV receiver to run room correction features (like Audyssey
or Dirac) and allow the receiver to optimize your speakers and subwoofer(s).
2
LED power
Amber: The subwoofer is connected to power and in standby mode.
indicator
Green: The subwoofer is on and ready to use.
3
Phase
Tap the +/- buttons next to Phase to adjust the phase setting. If you're using a single
control
subwoofer, you can generally leave the phase at 0 degrees. However, you may need to
change the phase depending on your speaker arrangement.
4
Auto on /
Auto On: Subwoofer wakes up as soon as it receives an audio signal and goes into standby
Always on
~20 minutes after the audio signal is stopped.
switch
Always On: Subwoofer never enters Standby. Use this mode if you have a means of controlling
the main AC power to the subwoofer.
5
Low-pass
If your AV equipment doesn't have its own low-pass filter, you can adjust the low-pass
control
filter higher or lower as preferred. If you connect an LFE cable from your AV receiver to the
subwoofer, the subwoofer automatically switches to LFE mode. With the subwoofer in LFE
mode, configure crossover settings in you AV receiver.
6
LFE Input
LFE (low-frequency effects) is recommended for AV receivers with a dedicated LFE channel or
subwoofer pre-out. See the previous page for connection instructions.
7
Line Inputs
This method is recommended for systems with no LFE/subwoofer output jack, such as
2-channel systems. See the previous page for connection instructions.
8
Main On/Off
Use to completely cut the power to the subwoofer. Similar to removing the power cord.
Switch
9
AC power
Used to provide power to the subwoofer with the included power cable.
inlet
2
1
3
6
4
6
5
7
Publicidad
