Publicidad
a. Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
b. Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source and/or the battery pack from the power tool
before making any adjustments, changing accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the power tool's operation. If damaged,
have the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in accordance with these instructions,
taking into account the working conditions and the work to be performed. Use of the
power tool for operations different from those intended could result in a hazardous situation.
h. Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for safe handling and control of the tool in
unexpected situations.
a. Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
WARNING
• Always wear eye, ear and breathing protection.
• Do not apply too much pressure when engraving.
• The use of an accessory or attachment, other than those recommended in this
Instruction Manual, may present a risk of personal injury.
To use this tool properly, you must observe the safety regulations, the assembly instructions and
the operating instructions to be found in the Manual. All persons who use and service the machine
have to be acquainted with this Manual and must be informed about its potential hazards. Children
and infirmed people must not use this tool. Children should be supervised at all times if they are
in the area in which the tool is being used. It is also imperative that you observe the accident
prevention regulations in force in your area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made to the tool nor for any damage
resulting from such changes.
The declared vibration total value declare does not exceed 2,5 m/s
accordance with a standard test method and may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
WARNING:
• the vibration and noise emissions during actual use of the power tool can differ from the
declared values depending on the ways in which the tool is used especially what kind of
workpiece is processed;
• it's necessary to identify safety measures to protect the operator that are based on an
estimation of exposure in the actual conditions of use (taking account of all parts of the
operating cycle such as the times when the tool is switched off and when it is running idle in
addition to the trigger time).
DT ISTR (1780) 04/19_Rev.1_06/20
4. Power tool use and care
5. Service
ENGRAVER SAFETY WARNINGS
2
, it has been measured in
1780
12/32
Publicidad
