Publicidad
Idiomas disponibles
Idiomas disponibles
7.5
Parameter reset (Factory Reset)
By means of this procedure it is possible to delete all set parameters and restore the original
factory setting. This function should be used in those cases where errors or unwanted varia-
tions have been introduced, choosing to reset everything and return to the initial conditions.
This procedure is carried out as described below.
1. From Machine
OFF, switch the ma-
chine ON with the unit
lever in the dispens-
ing position (contact
closed); the machine
does not perform any
action but waits for
a few seconds for a
sequence from the
operator.
Keep the lever
2.
in the dispensing
contact position.
After a few seconds,
if the lever has al-
ways remained in the
same position, the
machine turns on the
yellow light (as for
normal programming)
for 5 seconds until the
flashing green light
appears.
APPARTAMENTO
3. If, within 3 sec-
onds of the green light
coming on, the lever
is returned to rest, a
factory parameter re-
set (default) is imple-
mented, indicated by
the permanence of
the steady green light.
If, on the other hand,
the lever is left in the
dispensing position,
after the 3-second
time limit has elapsed,
the green indicator
light will remain flash-
ing without performing
a parameter reset,
waiting for a Poweroff.
4. Switch off the
machine and if the
reset procedure is not
implemented, return
the lever to the home
position anyway.
61
Publicidad
