Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DESCRIPTION
THIS MANUAL IS FOR THE FOLLOWING MODELS:
FO-473-TX
HDMI 1.3 extension-distributor transmitter over IP.
FO-474-RX
HDMI 1.3 extension-distributor receiver via IP.
-
Increases the transmission distance of HDMI FULL HD 1080p signals up to 120 m via Cat 6 cable.
The use of Cat 6 cables makes it easier to run the cable through pipes and walls, reducing the difficulty
and time required for installation.
-
It features HDMI signal compression and transmission technology over low bandwidth data networks.
-
The system is easily scalable, as the HDMI signal is transmitted with direct connection or via the ethernet
network with Gigabit switch (1 Gbps) and IGMP Snooping function, allowing up to 253 receivers to be
connected and providing 1080p@60Hz resolutions.
-
In addition, the remote control transmitter allows remote control of the video source from the TV position.
CONTROLS AND FUNCTIONS
TRANSMITTER (mod. FO-473-TX)
FO-473-TX
1
5 V DC, 2 A
FO-473-TX
1.- Power supply input for the mains adapter provided.
FO-474-RX
1
2.- INPUT: digital A/V signal input, HDMI female connector.
1
3.- IR OUT: output for connection of remote control transmitter. Connect the cable labelled TX to this CAT
port.
4.- 5e/6: transmitter output, RJ-45 connector.
5.- RESET: reset button. Press this button to reset the transmitter if the display shows CHECK TX'S INPUT
5 V DC, 2 A
SIGNAL.
IR IN
RECEIVER (mod. FO-474-RX)
FO-474-RX
1
IR IN
1.- IR IN: Input for connection of the remote control receiver. Connect the cable labelled RX to this CAT
port.
2.- 5e/6: receiver input, RJ-45 connector.
3.- RESET: reset button. Press this button to reset the receiver if the display is not receiving a signal.
4.- Power supply input for the mains adapter provided.
5.- OUTPUT: digital A/V output signal, HDMI female connector.
2
INPUT
2
2
3
INPUT
CAT 6
RESET
2
3
CAT 6
RESET
3
IR OUT
3
4
IR OUT
5 V DC, 2 A
4
5 V DC, 2 A
- 2 -
4
5
CAT 6
RESET
4
5
5
CAT 6
RESET
OUTPUT
5
OUTPUT
Publicidad
