Publicidad
KS — RT515 C/J
m Pinch roller ass'y (See Figs. 4-15 and 4- 16)
. 1) Remove two C washers © securing the pinch roller
ass'y (do this for both the FF and REV modes).
2) Pull out the pinch rollers.
* How to install
FWD/REV plate
"The FWD/REV piate will
be free if is moved slightly
head base and pinch roller spring.
from the right to the left.
The pinch roller stud should be inserted between the
Reel disk ass'y (See Fig. 4-17)
1) Remove the cassette holder and sub chassis.
2) While pushing
down
the reel driver (reel feather),
Fig. 4-15
remove the C washer at the tip. (You can remove the
spring, reel disk, and the washer on the disk as well.
Use care when you put them back in place.)
During assembly, the pinch roller
stud shold come betwen the head
base and spring.
Note: How to operate the FWD/REV plate
To move it to the right from the left most position;
Push this direction plate to the right
(stop at the predete rmind position.)
Pinch roller shaft
-—
oO,
Next push the FWD/REV
[2] plate to the right.
Direction plate
Head base
mode gear(B)
©
Fig. 4-16
Pinch roller spring
When removeing the reel disk,
push down the reel feather in
FWOD/REV plate
the direction of the arrow.
This is where the toggle spring is installed
@r
Cl =)
1) Push the direction plate to the right (stop it at the
CC)
©)
predete rmind position).
Fig. 4-17
2) Then, push the FWD/REV plate to the right.
Left direction
FWOD/REV plate
=
How to thread
the main belt,
After assembling, bend tabs @ in order
to hold the disk board in place.
Fig. 4-19
30 (No. 49282)
Publicidad
