RIB KIT PRINCE PLUS 24V Instrucciones De Instalación página 33

closed anyway. It turns off only when the gate is totally closed.
This warning signal is not enabled during the programming procedures.
N.B.: 3W Max. If you overuse the push button panels or the lamps,
the control board logic system may be compromised,
resulting into a possible operation block.
T
ECHNICAL DATA
- Moisture
- Power supply voltage
- Frequency
- Battey supply
- Weight without battery
- Power transformer
- Absorption max
- Transient power mains drops
- Max. capacity of the warning light - gate open -
- Max load flasher
- All the inputs must be used as clear contacts because the power
supply is generated inside (safe power) the control panel, and it has
been laid down in such a way to guarantee a double or strengthened
insulation in relation to the parts with dangerous power.
- Eventual external circuits connected to the outputs of the control
board or of the expander card must be carried out making sure that a
double or strengthened insulation is used in relation to parts with
dangerous power.
- All inputs are run by a programmed integrated circuit which does a self
check every time it starts operating.
< 95% without condensation
230V~ ±10% (on request
120V±10% )
50/60 Hz
20-24,5Vdc
kg 3,0
130VA - V primary 230 Vac - V
secondary 18Vac
25 mA
100ms
12Vdc 3 W
(corresponding to 1 3W lamp
or to 5 LEDS with 2,2 k
resistance In series)
24Vdc 20W
G G
B B