cecotec ENERGYSILENCE AERO 5250 WHITEWOOD Manual De Instrucciones página 48

ENGLISH
Fan assembly and suspension. Fig. 7
Fig. 7 key:
1. Electric wiring
2. Hanging ball slot
3. R clip
4. Adapter
5. Canopy
6. Canopy decorative cover
7. Pin
8. Locking screw
- If you want the fan to hang lower, you must remove the hanging ball from the supplied 6
inch downrod for use with a longer rod (included). (If you wish to use the 6-inch downrod,
follow the steps below).
- To remove the hanging ball, loosen the suspension ball locking screw and remove the
pin and clip. Lower the hanging ball and remove the clevis pin. Slide the hanging ball off
the downrod, and slide it onto the longer rod (note that the top of the rod has a hole for
the locking screw). Insert the stop pin into the top of the extended downrod and raise
the hanging ball. Make sure that the stop pin is aligned with the slots on the inside of the
hanging ball, tighten the fixing screw securely.
Tip: to prepare for passing the electrical wires through the rod, attach a small piece of
electrical tape to the ends of the electrical wires to hold them together when passing them
through the rod.
2. Loosen the main-body attachment fixing bolts and nut at the top of the motor housing.
Remove the pin and rod clip (if you have not already done so). Slide the rod down through
the canopy.
3. Pass the electrical wires through the rod and pull the wires protruding from the top of the
rod end.
4. Place the main-body attachment downrod into the main body anchorage of the motor
housing and insert the pin and clip previously removed. Tighten the fixing bolts and the
main-body attachment nut securely. Lower the canopy onto the motor housing
Connection of the remote control receiver. Fig. 8
Canopy assembly. Fig. 9
5. Lift the canopy up to the mounting bracket, aligning the loosened screws in the bracket
with the holes in the canopy. Turn the canopy to lock it. Re-insert the screws and secure
them all with a screwdriver.
48
ENERGYSILENCE AERO 5250 WHITEWOOD/ BLACKWOOD