cecotec ENERGYSILENCE AERO 5250 WHITEWOOD Manual De Instrucciones página 49

6. Once you have secured the mounting bracket to the connection cover, you can hang the
fan. Hold the fan firmly with both hands. Slide the downrod through the opening in the
mounting bracket and allow the ball to rest on the bracket. Rotate the hole in the hanging
ball until it aligns with the tab on the mounting bracket.
Tip: have someone else hold the ladder securely and bring the fan closer to you once it is on
the ladder.
Blade assembly. Fig. 10
Time saver: blade bolt washers can be installed on each blade prior to installation.
7. Align the holes in the blades with the screw holes in the motor. Once all blades are
attached, tighten all the screws. Before securing screws permanently, repeat with the
remaining blades.
Note: tighten the blade screws a second time.
LED-Lamp assembly. Fig. 11-12-13
8. Unscrew the screws. Attach the LED plate to the bottom of the fan by inserting the fixing
screws into the holes. Then turn it until it is firmly in place. Next, screw in the previous
fixing screw by aligning the hole in the screw and the hole at the bottom of the fan.
Finally, tighten the other two fixing screws to secure the LED plate. Fig. 11
NOTE: during the installation or when the LED lamp is removed, keep the insulation pads
intact. Over-tightening the screws may damage them.
9. Replace the lamp cover and lamp shade. Fig. 12
10. Restore the cover and the lamp shade back to the LED panel, and secure them with
decorative clips and bolt nuts. Fig. 13
4. OPERATION
Fig. 14
1. Power indicator light
2. Speed buttons
3. Off button
4. Timer buttons
5. Light
6. Remote control battery
7. Winter/Summer function (reversal of blade rotation direction)
ENERGYSILENCE AERO 5250 WHITEWOOD/ BLACKWOOD
ENGLISH
49