Publicidad
Idiomas disponibles
Idiomas disponibles
Fuel Tank Filter
•
•
•
•
•
Install fuel cap.
Fuel Filter
•
To clean, remove screws, remove outer casing, and drain fuel.
•
Lift and hold onto the clamp, then remove hose from tank.
•
•
•
•
Install hose and clamp.
•
Open fuel valve. Inspect for leakage.
•
Install outer casing and tighten screws.
Storage andTrans portation ofth e Generator:
When transporting the generator, turn the 3 in 1 Start Switch ( ON
prevent fuel spillage. Fuel vapor or spilled fuel may ignite.
•
Remove any debris that has collected on the generator and around the muffler and control panel. Use a brush or vacuum
to remove loose dirt.
•
Inspect air cooling slots. Remove any debris if obstructed.
For short-term storage, start the generator once every 7days.
•
•
For semi-long term storage, add fuel stabilizer to prevent stale fuel from causing acid and gum deposits in the fuel system
and carburetor.
•
For long-term storage, drain the fuel.
•
Store indoors to prevent freezing and use aprotective cover to protect from dust.
•
The generator must be Shipped, Run, and Stored in the upright position as seen
in this image.
MAINTENANCE
and Choke) OFF. Keep the generator level to
O /
F F
22
Publicidad
