Saunier Duval SDH 10-020 MCNHWI Manual De Usuario página 80

7- INDICATORS ON THE DISPLAY OF REMOTE CONTROL
7.1- INDICATORS ON THE DISPLAY OF REMOTE CONTROL
NOTE
The above illustration which displays all indicators at the same time is shown for informational
purposes only.
Transmission indicator
This indicator appears when the remote controller transmits
signals to the indoor unit.
Mode indicators
According to the selected operation following mode indi-
cators appear on the display: AUTO (), COOL (),
DRY (), HEAT () , FAN ONLY ().
ON/OFF indicator
This indicator appears on the display as long as the air
conditioner is switched ON. When the unit is switched OFF
the indicator is cleared from the display.
Temperature indicator
Displays the temperature setting (17°C – 0°C). If the FAN
ONLY mode is selected, the temperature indicator is not
displayed.
Time indicator
Displays the timer AUTO-ON/OFF time (0 – :50 hours) or
the clock.
The clock is only displayed if no timer AUTO-ON/OFF settings
are selected. As long as the AUTO-TIMER function is operating
the AUTO-ON/OFF time is displayed. To display the current
time press the CLOCK button in the lower control panel of the
remote control.
Fan speed indicator
Displays the selected fan speed in the AUTO mode and in
the three fan speed levels "" (LOW), "" (MED), and "" (HIGH).
As long as the modes AUTO or DRY are selected, AUTO is
displayed.
LOCK indicator
This indicator is displayed as long as the LOCK function is
selected. After LOCK function is cancelled by pressing LOCK
button again, this indicator is cleared from the display.
SLEEP indicator
This indicator is displayed as long as the SLEEP function is
selected. After SLEEP function is cancelled by pressing SLEEP
button again, this indicator is cleared from the display.
8 8