Turbosound MANCHESTER Serie Guia De Inicio Rapido página 4

6
MANCHESTER Series
Cardiod BFF (back, forward, forward)
Using 4-Core NL4 cable, 2 DSP and 2 ampli er channels
LAB GRUPPEN PLM + Series
Ampli er outputs con gured
in LAKE software on
pins 1 +/- and 2 +/-
All cables are NL4 - NL4 four-conductor
with standard wiring
(1+/- to 1+/- and 2+/- to 2+/-)
Cardiod:
1 Reversed
2 Forward
MS215
FRONT Preset
Patched to Pins 1+/-
THIS NL4 USES
PINS 1+/- and 2+ / 2-
MS215
THIS NL4 USES
PINS 1+/- and 2+ / 2-
FRONT Preset
Patched to Pins 1+/-
THIS NL4 USES
PINS 1+/- and 2+ / 2-
BACK Preset
Patched to Pins 2+/-
Connections
Mode Back Panel Connector
MV212
BI-AMP, Input Low +
Ampli er Channel 1
BI-AMP, Input Low -
BI-AMP, Input High +
MV212-XV
Ampli er Channel 2
BI-AMP, Input High -
Input SUB +
MS215
Input SUB -
MS215 and MS218 Front Input uses Pins 2+/2-
* Note: earlier models use Pins 1+/1-
MS218
*Note: Earlier models of the MS215 and MS218 subwoofers have a front input which is wired on Pins 1+/1-.
To update the front input to use Pins 2+/2-, follow this procedure:
1. Remove the screws that attach the front grille to the subwoofer.
2. Carefully pull off the grille, and do not pull on the front input wires. The cable length to the front NL4 is short, so support the grille while the cable is still attached.
3. Release the FASTON tab spade connectors by pressing on the tab in the middle of the connector with a small flat head screw driver.
4. Swap from pin 1+/- to pin 2+/-. The FASTON connectors will click into place when they are correctly connected.
5. Make sure that the wires are securely connected and with the correct polarity.
6. Securely reattach the front grille.
7
Quick Start Guide
Internal Schematic
+
MHF 1
1+
-
NL4
1-
+
Input/
2+
Link MHF 2
2-
-
+
1+
LF 1
NL4
1-
-
Input/
2+
Link
2- +
1+ LF 2
1-
-
2-
2+
1+
NL4
1-
+
Input/
2+
Link MHF
2-
-
+
1+
LF 1
NL4
1-
-
Input/
2+
Link
2- +
LF 2
-
+
1+
LF 1
NL4
1-
-
Input/
2+
Link
2 -
1+
1-
+
2-
1+
NL4 LF 2
2+
1- -
Input/
2+
Link
2 -
1+ NC
NL4
1-
NC
Front
2+
Input
2 -