Ruijie Reyee RG-ES106D-P V2 Manual Del Usuario página 4

2. Wall Mounting
Step 1 Take out two expansion anchors and two screws from the packing materials.
Step 2 Drill two holes on the wall. The holes should be level with each other and their
centers should be 112.6 mm (4.43 in) apart. Hammer the two expansion anchors into the
holes, and drive two screws into the expansion anchors.
Step 3 Place the two keyholes on the back of the switch ver the two screws mounted on
o
the wall, and pull the switch down slightly to hang it on the screws
.
Network Configuration
Connect the switch according to your networking needs. The switch does not need any
configuration after being connected.
Power Supply
Grounding Cable
PC
PoE Powered Device
Printer
IP Camera AP IP Telephone
2