Causes Of Damage; Protecting The Environment; General Notes; Exhaust Air Mode - Bosch HUI50351UC Manual De Instalación

Causes of Damage

NOTICES:
Risk of damage due to corrosion. Always turn
▯
appliance on when cooking to avoid condensation
buildup. Condensation can lead to corrosion
damages.
Always replace defective bulbs immediately to avoid
▯
an overload of the remaining bulbs.
Risk of damage due to ingress of humidity into the
▯
electronic circuitry. Never clean operator controls with
a wet cloth.

Protecting the environment

Unpack the appliance and dispose of the packaging in
an environmentally friendly manner.

General Notes

Exhaust air mode

Note: Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct used
for ventilating furnace installation areas.
If the ventilation is intended to pass through a smoke
▯
or exhaust chimney that is not in operation, the
responsible area heating inspector must give
approval.
If the ventilation passes through an external wall, use a
▯
telescope wall sleeve.

Ventilation line

Note: The installer is responsible for proper installation
and functionality related to the duct section. Improper
installation affecting the use of the appliance is not the
responsibility of the appliance manufacturer.
The appliance achieves its optimum performance by
▯
means of a short, straight exhaust air duct and as
large a duct diameter as possible.
As a result of long rough exhaust air ducts, too many
▯
duct bends or duct diameters that are smaller than 6"
(150 mm), the optimum extraction performance is not
achieved and fan noise is increased.
The ducts or hoses for laying the exhaust air line must
▯
consist of non-combustible material.
Round ducts
An inside diameter of 6" (150 mm) is recommended,
with a minimum being 4
G e n e r a l N o t e s
" (120 mm).
_
Surface damage due to incorrect cleaning. Clean
▯
stainless steel surfaces in the grind direction only. Do
not use any stainless steel cleaners for operator
controls.
Surface damage due to strong or abrasive cleaning
▯
agents. Never use strong and abrasive cleaning
agents.
Risk of damage from condensation back flow. Install
▯
exhaust vent at a slight downward slope away from the
appliance (1° slope).
Flat ducts
The inner cross-section must correspond to the diameter
of the round ducts.
dia. 6" (150 mm) approx. 27
_
dia. 4 " (120 mm) approx. 26
Flat ducts should have no sharp deflections.
▯
Use sealing strip for deviating duct diameters.
▯

Electrical connection

WARNING
9
RISK OF ELECTRIC SHOCK
Parts inside the appliance can have sharp edges.
The connection cable can be damaged. Do not
bend or pinch connection cables during installation.
A 120 volt, 60 Hz AC-only electrical supply is required on
a separate 15 amp fused circuit.
Before connecting the appliance, check the household
electricity installation. Ensure sufficient fuse protection of
the household electricity installation. The voltage and
frequency of the appliance must match the electrical
installation (see rating plate).
The appliance complies with protection class 1 and must
only be operated in conjunction with a protective
conductor terminal.
An all-pole isolating switch with at least a
contact gap must be fitted in the installation. This must
remain accessible after installation.
Only a qualified electrician following the appropriate
codes and regulation may install, lay, or replace the
connecting cables.
)
^ sq in (177 cm
2
_
sq in (113 cm )
2
" (3 mm)
X
7