AERMEC MODUCONTROL Manual De Uso página 36

9 READINGS MENU
To access the readings menu, press the key in (Fig.4); once the readings menu has been accessed, the monitor will display the readings index and a 3-character string that
identifies it; the string will be displayed for one second, after which it is replaced by the value of the reading itself. To move on to the next reading, press the key in (Fig.5); to go
back to the previous one, press the key in (Fig.6). Every time you pass from one reading to another, apart from the change in the index value you will also see (for one second)
the string identifying the current reading (it is possible, however, to identify any reading via the value of the indicator, comparing it with the table below).
Fig. 4
Index - String
0 tuA
1 tiA
2 tSb
3 tGp
4 tAE
5 AP
6 bP
7 tEr
8 SAb
9 CP
A HC0
b HC0
C SP0
Key:
: Parameter visible on ALL the units
: Parameter ONLY visible on units suitable for production of hot water
: Parameter ONLY visible on units with condensation control device on board
: Parameter ONLY visible on units fitted with twin compressor
: Parameter ONLY visible on units fitted with inverter compressor
36
Fig. 5
Meaning of the reading
Water Outlet Temperature
Water Inlet Temperature
Coil temperature
Discharge refrigerant temperature
External air temperature
Delivery pressure
Suction pressure
Thermostat
Safety band on Force-Off
CP times
Hours of operation (thousands)
Hours of operation (units)
Compressor pickup current (thousands)
Fig. 6
Index - String
d SP0
E rEL
F bLd
G SEt
H dCP
i dCP
Operating hours COMPRESSOR 2 (thousands)
J HC1
L HC1
N SP1
o SP1
P Po
Q rFQ
r PrF
Meaning of the reading
Compressor pickup current (units)
Software release
Minor software releases
Setting currently in use
DCP pressure setting
DCP pressure differential
Operating hours COMPRESSOR 2 (units)
Compressor pickup current COMPRESSOR 2
(thousands)
Operating hours COMPRESSOR 2 (units)
Power fraction
Required frequency (INVERTER)
Pressure drop