Hisense Hi-Therma Serie Manual De Instalación Y Mantenimiento página 18

TRANSPORTATION AND HANDLING
4 TRANSPORTATION AND HANDLING
Transport the product as close to the installation location as
possible before unpacking.
!
C A U T I O N
• Do not step on or put any materials on the product.
•
Do not put any foreign material into the outdoor unit and check to
ensure that none exists in the outdoor unit before the installation and
test run. Otherwise, a fire or failure, etc. may occur.
When manually lifting the unit using the handles, pay attention
to the following points.
•
To prevent the unit from overturning, pay attention to the center of
gravity as shown in the below figure.
•
Two or more personnel should be used to move the unit.
Handle
Fall angle of the outdoor
unit
20°
center of
gravity
5 BEFORE OPERATION
!
C A U T I O N
• When the system is started after a shut-off longer that approximately
3 months, it is recommended to check the system by your service
contractor.
• Make sure that the outdoor unit is not covered with snow or ice. If
covered, remove it by using hot water (approximately 50°C). If the
water temperature is higher than 50ºC, it will cause damage to
plastic parts.
5.1 LINE-UP OF OUTDOOR UNITS
44(2.0HP)
Capacity
AHW-044HCDS1
Model
5.2 FACTORY-SUPPLIED UNIT COMPONENTS
Check to ensure that the following accessories are packed with
the outdoor unit.
Accessory Image
Instruction
manual
Drain nozzle
Flare Nuts
?
N O T E
• The previous accessories are supplied inside the unit.
• If any of these accessories are not packed with the unit or any
damage to the unit is detected, please contact your dealer.
7
60(2.5HP)
AHW-060HCDS1 AHW-080HCDS1
Qty. Purpose
Basic instructions for the
1
installation of the device
For water discharge when
1
necessary.
Piping connection for
1
Φ6.35
liquid stop valve
Piping connection for
1
Φ12.7
gas stop valve
80(3.0HP)