SEVERIN TO 2066 Instrucciones De Uso página 15

Mini horno tostador-asador
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
food can protrude or come off during the
cooking process.
∙ Inserting and removing the rotating spit:
∙ Place the loaded spit onto the handle
assembly. Ensure that the spit is
safely supported in the recesses in
the handle.
∙ Slide the spit end-piece with the drive
unit connection into the drive unit (see
picture II).
∙ Place the idle end of the spit into its
holding bracket on the opposite side
(see picture I).
∙ To remove the rotating spit, follow
these steps in reverse order.
Pizza stone
∙ Always place the pizza stone on the
middle of the baking rack before
inserting the rack into the appliance.
∙ Preheat the appliance to the required
temperature as described in the section
Operation.
∙ With certain pre-baked pizzas made
from especially light dough, the pre-
heating phase should be shortened;
this is to prevent the bottom layer of the
pizza dough from browning too fast.
∙ After pre-heating, open the door and
use a spatula to place the pizza on the
centre of the stone. The pizza should be
slightly smaller than the stone so that
there is a clear space all round it.
∙ The pizza is ready once the cheese
topping has melted and the bottom
of the dough is slightly brown. Use a
spatula for removing the pizza and
serving it.
Operation
∙ Before using the appliance, make sure
that the crumb tray is fitted in its proper
position underneath the lower heating
element.
∙ Pre-heat the oven compartment for
several minutes with the door closed,
using both heating elements. Set the
temperature control knob to the required
level and use the timer control knob to
select the desired pre-heating time.
∙ Place the food to be cooked on the
baking rack. When cooking food
containing fat or moisture, use the
baking tray to stop any dripping into the
interior of the appliance.
If the pizza stone is used, it should be
placed straight onto the baking rack.
∙ Close the door, set the temperature
control to the required level, turn the
6-position switch to the desired function,
and use the timer knob to select the
desired cooking time.
∙ After the pre-programmed cooking time
has elapsed, the timer will automatically
switch off the appliance.
∙ To switch off the appliance earlier, set
the timer to its OFF position.
∙ Always use the door handle to open the
hot door after use.
∙ When removing the baking tray or rack,
use the tray/rack handle. Likewise, when
removing the spit, the spit handle must
be used. Always place the baking tray
and rack on a heat-resistant surface.
∙ Remove the plug from the wall socket
after use.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido