Philips GC3580 serie Manual Del Usuario página 12

Problem
EN The iron is plugged
in, but the soleplate
is cold.
The iron does not
produce any
steam.
The iron does not
produce a
steam boost.
Water droplets
drip onto the fabric
during ironing.
12
Possible cause
The temperature dial
is set to MIN.
There is not enough
water in the water
tank.
The steam control is
set to position .
The iron is not hot
enough.
You have used the
steam boost function
too often within a very
short period.
The iron is not hot
enough.
There is not enough
water in the water
tank.
You have not closed
the cap of the filling
opening properly.
You have put an
additive in the water
tank.
The set temperature
is too low for steam
ironing.
You have used the
steam boost function
at a temperature
setting
below 3.
Solution
Set the temperature dial to the
required position.
Fill the water tank (see
Set the steam slider to position
or . (see ).
Set an ironing temperature that
is suitable for steam ironing (2
to MAX). Put the iron on its heel
and wait until the temperature
light has gone off before you
start ironing.
Continue ironing in horizontal
position and wait a while
before you use the steam boost
function again.
Set an ironing temperature at
which the steam boost function
can be used ( 3 to MAX).
Put the iron on its heel and wait
until the temperature light has
gone off before you use the
steam boost function.
Fill the water tank (see
Press the cap until you hear
a click.
Rinse the water tank and do not
put any additive in the water
tank.
Set a temperature of 2 or
higher.
Set the temperature dial to a
setting between 3 and MAX.
).
).