Intended Use - Makita DUC256 Manual De Instrucciones

Saw chain type
Number of drive links
Guide bar
Sprocket
WARNING:
Use appropriate combination of the guide bar and saw chain. Otherwise personal injury may
result.
Symbols
The followings show the symbols used for the equipment. Be
sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Wear ear protection.
Wear a helmet, goggles and ear protection.
Use appropriate protection for foot-leg and
hand-arm.
This saw is to be used by properly trained
operators only.
Do not expose to moisture.
Maximum permissible cut length
Always use two hands when operating the
chain saw.
Beware of chain saw kickback and avoid
contact with bar tip.
Direction of chain travel
Saw chain oil adjustment
Guide bar length
Cutting length
Pitch
Gauge
Type
Number of teeth
Pitch
Only for EU countries
Ni-MH
Li-ion Do not dispose of electric equipment or
battery pack together with household waste
material!
In observance of the European Directives,
on Waste Electric and Electronic
Equipment and Batteries and Accumulators
and Waste Batteries and Accumulators
and their implementation in accordance
with national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.

Intended use

The tool is intended for cutting branches and pruning
trees. It is also suitable for tree service.
Noise
The typical A-weighted noise level determined accord-
ing to EN ISO 11681-2:
Model DUC256
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model DUC306
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model DUC356
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model DUC406
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model DUC256C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
8 ENGLISH
25AP
60
250 mm
253 mm
1/4"
1.3 mm
Carving bar
9
1/4"
) : 89 dB(A)
pA
) : 103 dB (A)
WA
) : 89 dB(A)
pA
) : 103 dB (A)
WA
) : 89 dB(A)
pA
) : 103 dB (A)
WA
) : 89 dB(A)
pA
) : 103 dB (A)
WA
) : 89 dB(A)
pA
) : 103 dB (A)
WA