Preparation Of Coffee; Programming The Dispenser Buttons - illy Y3 IPERESPRESSO Instrucciones De Uso

PREPARATION OF COFFEE

• Use only illy Iperespresso capsules
• Place the cup underneath the coffee spout
• Slowly lift the control lever (1) backwards (until it stops) (Fig. 7) and introduce
a capsule in the slot provided (Fig. 8)
• Close the lever (1) (Fig. 9) completely and press one of the dispensing buttons:
short (A), big (B) according to your taste (Fig. 10)
NOTE
The machine is equipped with a pre-infusion system: when one of the coffee
buttons - (A) or (B) – is pressed, the machine begins to make coffee, stops,
and automatically restarts until the programmed volume has been delivered.
• Repeat the steps above for additional cups of coffee using a new capsule for
each drink
• To expel used capsules, slowly lift the lever and the capsule will automatically
fall into the used capsule tray.
Repeat if unsuccessful.
WARNING:
Before introducing a capsule into the coffee machine, lift the control
lever (1) on the top of the machine slowly and fully. For proper
hygiene, and to preserve the high product quality, it is advisable
to eject the capsule soon after the drink has been dispensed.
USEFUL TIP:
Use thick cups when preparing Espresso and heat them beforehand. This will
keep your coffee warm longer. Cups can be heated under hot running water.

PROGRAMMING THE DISPENSER BUTTONS

Big cup: Press and hold the button (B). The machine will start delivering water.
Once the desired water level is reached release the button (B). The machine will
then stop delivering water and the desired quantity will be memorized for future
dispensing. (Fig. 10)
Small cup: Press and hold the button (A). The machine will start delivering
water. Once the desired water level is reached release the button (A). The
machine will then stop delivering water and the desired quantity will be memorized
for future dispensing. (Fig. 10)
22
Fig. 7
Fig. 8
Fig. 9
Fig. 10