Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
A - ENGLISH
TABLE OF CONTENTS
Safety Precautions ....................................................................A-2
Machine Operation ....................................................................A-3
Machine Maintenance & Storage ..............................................A-3
Handle Release Assembly Instructions .....................................A-3
Handle Assy .....................................................................D-2 – D-3
Base Assy ........................................................................D-4 – D-5
Wiring Diagram ......................................................................... D-5
SAFETY PRECAUTIONS
This machine is intended for commercial use. It is constructed for use in an indoor environment and is not intended for any other use. Use only
recommended accessories.
All operators shall read, understand and exercise the following safety precautions:
1)
Do not operate machine:
•
Unless trained and authorized.
•
Unless you have read and understand operators manual.
•
In fl ammable or explosive areas.
•
With damaged cord or plug.
•
If not in proper operating condition.
•
In outdoor areas.
•
In standing water.
•
With the use of extension cords.
2)
Before operating machine:
•
Make sure all safety devices are in place and operate properly.
3)
When using machine:
•
Do not run machine over cord.
•
Do not pull machine by cord or plug.
•
Do not pull cord around sharp edges or corners.
•
Do not unplug by pulling on the cord.
•
Do not stretch cord.
•
Do not handle plug with wet hands.
•
Keep cord away from heated surfaces.
•
Report machine damage or faulty operation immediately.
4)
Before leaving or servicing machine:
•
Turn off machine.
•
Unplug cord from outlet.
5)
When servicing machine:
•
An experienced technician should only perform service work.
•
Unplug cord from outlet.
•
Use manufacturer supplied or approved replacement parts.
GROUNDING INSTRUCTIONS
This fl oor machine shall be grounded while in use to protect
the operator from electric shock. The machine is provided with
a three –conductor cord and a three contact grounding type
attachment plug to fi t the proper grounding type receptacle. The
green [or green and yellow] conductor in the cord is the grounding
wire. Never connect this wire to anything other than the grounding
pin of the attachment plug.
This machine is for use on a nominal 120-Volt circuit and has a
grounding plug that resembles the plug illustrated in fi gure below.
Make sure that the machine is connected to an outlet having the
same confi guration as the plug. No adapter should be used with
this machine.
A - 2
INSTRUCTIONS FOR USE
Page
CFP Pro 1715HD, 2015HD - 56091116
Grounding Pin
FIGURE 1
Adapte
Metal Scre
Grounded Outlet
Grounded Outlet Box
12/13
Publicidad
Tabla de contenido
