Control Board - Ibiza Light FXBAR70 Manual De Instrucciones

CONTROL MENU MAP
Mode
DMX mode
Static colors
Show
Sound Mode
Edit color
Slave
Information
Direction set
OPERATION
PROJECTOR DMX STARTING ADDRESS SELECTION
All fixtures should be given a DMX starting address when using a DMX signal, so that the correct fixture res-
ponds to the correct control signals. This digital starting address is the channel number from which the fixture
starts to receive the digital control information sent out from the DMX controller. The allocation of this starting
address is achieved by setting the correct number on the display located on the base of the device.
You can set the same starting address for all fixtures or a group of fixtures, or allocate a different address to
every fixture individually.
If you set the same address, all the units will react to the same control signal from the same channel number.
In other words, changing the settings of one channel will affect all fixtures simultaneously.
If you allocate different addresses to the units, each unit will react to the channel number that you have set,
based on the quantity of control channels of the unit. That means changing the settings of one channel will
affect only the selected fixture.

CONTROL BOARD

The Control Board offers several features: you can simply set the starting address, run the pre-programmed
programs or make a reset.
The main menu is accessed by pressing the Mode-button until the display starts flashing. Browse through the
menu by pressing the UP/DOWN buttons. Press the Enter button in order to select the desired menu. You can
change the selection by pressing the UP/DOWN buttons. Confirm every selection by pressing the Enter button.
You can leave every mode by pressing the Mode button. The functions provided are described in the following
sections.
SET DMX ADDRESS
Display the DMX 512 value of each channel. With this function you can display the DMX 512 value of each
channel. The display automatically shows the channel with a value changing.
4
MANUAL - FXBAR70
Programming
26CH
23CH
Addr
6 CH
2 CH
StAt CL00-CL20
Sh 1-7
Shou Sp 1-9
St 0-9
So 1-4
Soud
Sen1-9
r000-255
g000-255
b000-255
Colo
U000-255
S000-255
St 0 – St 9
SLAV Slave
Info ver
--->
dir
<---
©Copyright LOTRONIC 2019
Description
d001-d487
d001-d492
d001-d507
d001-d511
RGB static color
Program Show 1-7
Program Speed 1-9 (slow->fast)
Program Flash 0-9 (slow->fast)
Sound Program show 1-4
Mic Sensitivity
Red (0-100%)
Green (0-100%)
Blue (0-100%)
7cree LED (0-100%)
5730 SMD (0-100%)
LED Strobe (slow->fast)
Slave
VVxx Soft version
Set to the right
Set to the left