For Your Safety - Tecsis P3290 Manual De Instrucciones

5. For your safety

5. For your safety
Select the appropriate pressure sensor with regard to scale range,

!
performance and specific measurement conditions prior to installing and
starting the instrument.
Warning
Observe the relevant national regulations (e.g. EN 50178) and observe the

applicable standards and directives for special applications (e.g. with
dangerous media such as acetylene, flammable gases or liquids and toxic
gases or liquids and with refrigeration plants or compressors). If you do
not observe the appropriate regulations, serious injuries and/or damage
can occur!
Open pressure connections only after the system is without pressure!

Please make sure that the pressure sensor is only used within the overload threshold limit

all the time!
Observe the ambient and working conditions outlined in section 7 „Technical data".

Observe the technical data for the use of the pressure sensor in connection with

aggressive / corrosive media and for the avoidance of mechanical hazards.
Ensure that the pressure sensor is only operated in accordance with the provisions i.e. as

described in the following instructions.
Do not interfere with or change the pressure sensor in any other way than described in

these operating instructions.
Remove the pressure sensor from service and mark it to prevent it from being used again

accidentally, if it becomes damaged or unsafe for operation.
Take precautions with regard to remaining media in removed pressure sensor. Remaining

media in the pressure port may be hazardous or toxic!
Have repairs performed by the manufacturer only.

Open circuit before removing connector / cover.

Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
GB
25