Bosch GCL 25 Instrucciones De Funcionamiento página 8

Point and Line Laser
Battery life for the operating modes
– Cross and point-line operation
– 5-Point operation
– Line operation
Weight
Dimensions (length x width x height)
Degree of protection
Inserting/Replacing the Battery
Protect the tool against moisture and Alkali-
manganese batteries are recommended for the
measuring tool.
To open the battery lid
the direction of the arrow and fold the battery
lid up. Insert the batteries. When inserting, pay
attention to the correct polarity according to the
representation on the inside of the battery lid.
When the batteries are low, the battery low
3
indicator flashes red. Additionally, the
laser beams flash for approx. 5 s every 10
minutes. When the flashing initially begins, the
Initial Operation
Protect the measuring tool
WARNING
!
against moisture and direct
sun light.
Do not subject the measuring tool
to extreme temperatures or variations
i n t e m p e r a t u r e . A s a n e x a m p l e ,
do not leave it in vehicles for long
t i m e . I n c a s e o f l a r g e v a r i a t i o n s
in temperature, allow the measuring tool
to adjust to the ambient temperature
before putting it into operation.
of extreme temperatures or variations in
temperature, the accuracy of the measuring tool
can be impaired.
Avoid heavy impact or falling of the
measuring tool.
After heavy exterior impact
on the measuring tool, an accuracy check
should always be carried out before continuing
to work (see "Levelling Accuracy").
Switch the measuring tool off during
transport.
When switching off, the levelling
unit, which can be damaged in case of intense
movement, is locked.
GCL 25 Manual with translations.indd 8
Technical Data
Assembly
9 8
, slide the latch in
Operation
In case
-8-
GCL 25 Professional
12 h
20 h
30 h
1.32 lbs
6.1 x 2.2 x 4.6 in (155 x 56 x 118 mm)
IP54 (dust and splash water protected)
measuring tool can be operated for approx.
1 more hour. When the batteries become
empty, the laser beams flash one more time
directly prior to the automatic shut-off. Always
replace all batteries at the same time. Only use
batteries from one brand and with the identical
capacity.
Remove the batteries from the measuring tool
when not using it for extended periods. When
storing for extended periods, the batteries can
corrode and discharge themselves.
Switching On and Off
switch on
To the measuring tool, slide the
On/Off switch 4 to the "
working without automatic levelling) or to the "
on" position (when working with automatic
levelling). Immediately after switching on, the
measuring tool sends laser beams out of the
exit openings 1.
Do not point the laser
WARNING
!
b e a m a t p e r s o n s o r
animals and do not look into the laser
beam yourself, not even from a large
distance.
switch off
To the measuring tool, slide the
On/Off switch 4 to the "off" position. When
switching off, the levelling unit is locked.
Deactivating the Automatic Shut-off
When no button on the measuring tool is
pressed for approx. 30 minutes, the measuring
tool automatically switches off to save the
batteries.
switch on
To the measuring tool after
automatic shut-off, either slide the On/Off
switch 4 to the "off" position and then switch the
measuring tool on again or press the operating
mode button 2 once.
on" position (when
4/24/12 8:29 AM