Peavey Escort 3000 Manual Del Usuario página 22

Ocultar thumbs Ver también para Escort 3000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
Connecting Microphone(s) or Line Input(s)
The Escort's powered mixer is designed to work with any good-quality, balanced, dynamic or condenser microphone such as Peavey's PV
series of microphones. Connect the microphone to the XLR (three-pin) input connector as shown (Fig.5). If using multiple microphones, connect
them in the order they will be on stage for easy adjustment to each microphone. To connect a line level device such as a keyboard, use a 1/4"
instrument cable and insert into the center of the XLR-1/4" combo connector as shown (Fig.6).
Fig. 5
Connecting Media Playback Sources
The Escort powered mixer will accept various media playback devices. For connecting
CD player or grounded record player use the CHANNEL 7 RCA Left and Right
connections. For connecting an MP3 player or smartphone with media playback use
the 3.5mm stereo connector. This will require a stereo 3.5 mm cable (03007820)
which can be found at your local Peavey dealer. When using a USB memory stick with
MP3 or other audio files stored on it, insert the memory stick into the USB connector
on CHANNEL 7 and use the screen and controls in the master section to navigate and
play back audio files(Fig.7).
Connecting Power
WARNING! Before connecting power make sure the power
switch is in the OFF position.
Connect the IEC power cord to the receptacle on the back panel of the unit
as shown (Fig.8), and then to a suitable electrical outlet. If an extension
cord is required, make sure it is a three-wire cord with an intact ground pin
to preserve the safety ground.
NOTE: FOR UK ONLY
As the colours of the wires in the mains lead of this apparatus may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
(1) The wire that is coloured green and yellow must be connected to the terminal
that is marked by the letter E, or by the Earth symbol, or coloured green or green
and yellow. (2) The wire that is coloured blue must be connected to the terminal that
is marked with the letter N, or the colour black. (3) The wire that is coloured brown
must be connected to the terminal marked with the letter L, or the colour red.
Fig. 6
i
®

Publicidad

Tabla de contenido
loading

Tabla de contenido