SEVERIN BR 7946 Instrucciones De Uso página 10

the accessory holder by its narrow end. After
use, replace the tool in the holder, ensuring
that the recess on the crevice tool mounting
is properly aligned with the corresponding
recess on the tool itself. Finally, fold the tool
back into the accessory holder.
Dual-purpose attachment
By turning the opening to its appropriate
position (against the dash mark), the dual-
purpose attachment can be used as an
upholstery brush or an upholstery tool. If the
marking is aligned with the arrow on the side
of the upholstery tool, the nozzle function is
selected. With the dash mark on the
opposite side, the attachment can be used as
an upholstery brush.
Upholstery tool
The upholstery tool is suitable for cleaning
smaller areas such as arm rests and chair
seats etc.
Upholstery brush
The brush tool is suitable for cleaning
uneven areas such as upholstered surfaces,
picture frames, rows of books etc.
The dual-purpose attachment can be simply
pulled out of the accessory holder. When
replacing the attachment on the holder,
ensure that the lateral ribs on the attachment
fit into the guide-slots in the accessory
holder.
Cleaning and care
●
Before cleaning the appliance, ensure it is
switched off and disconnected from the
power supply.
●
To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
●
Do not use abrasives or harsh cleaning
solutions.
- The housing of the unit and the
accessories may be cleaned with a dry or
slightly damp lint-free cloth.
Filters
●
Before any filter unit is cleaned or
replaced, always switch the appliance off
and remove the plug from the wall
socket.
The vacuum cleaner uses replaceable filters,
some of which can also be cleaned.
Hepa-filter inside the filter compartment
This filter is located in the Hepa-filter
compartment. Should the filter be visibly
dirty, replacement is recommended at the
same time as the dust container is emptied.
- Press the release button for the Hepa-
filter compartment and remove the lid.
- Remove the old Hepa-filter.
- Fit a new Hepa-filter.
- Replace the compartment lid and push it
into position until it locks into place.
Dust container with internal Hepa-filter
The dust container must be emptied and
cleaned as soon as the 'MAX' level mark on
the container has been reached.
However, if optimum vacuuming power is
required, it is advisable not to wait until the
'MAX' level mark has been reached, but to
empty the container more frequently; in
addition, regular cleaning of the internal
Hepa-filter is also recommended.
To empty and clean the dust container,
proceed as follows:
- Press the dust container release and lift
out the container by its handle.
- Hold the full dust container over a
rubbish bin and press the base release
(located at the base of the container).
The base opens and the contents empty
into the bin.
- After emptying, the inside of the
container should be thoroughly cleaned
with a dry cloth.
Hepa-filter in dust container and filter
guard
The internal Hepa filter inside the dust
container can be cleaned or replaced.
7