Intex 57135 Manual Del Usuario página 9

NOTICE!
Risk of damage!
Handling the pool improperly could damage it.
− Never inflate the air chambers so that they are excessively
firm; instead only inflate them until the surface is firm.
− Never use an air compressor to inflate the pool.
− Do not pull the inflated pool over the ground.
− Set up the pool in the location where you would like to use it.
− Do not inflate the pool at low temperatures.
To set up the pool, proceed as follows:
1. Spread the pool out on level ground, which is not too hard, with the bottom
side facing downwards. Make sure that the distance between the pool and
other objects is at least 6.6 ft (2 m).
2. Close the outer ring valve
opening (see Fig. C).
3. Remove the small plug from the outer ring valve, insert a hand pump into it,
and pump up the outer ring.
4. Push the small plug firmly back into the outer ring valve.
5. Open the other air chamber valves
air chambers of the pool one after the other.
6. Close all valves by pushing the plugs down firmly once the air chambers
have been inflated to the desired extent.
If necessary, let some air escape from the air chambers if the pool loses its
proper shape.
7. Close the drain
8. Inflate the sea snake
If you want to use the water sprayer
sprayer connection
sprayer."
9. Slowly fill the pool with water.
10. Inflate the dinosaur figure
11. Inflate the rings
Children can now use the pool, the slide
10
by inserting the large plug firmly into the
11
6 .
and set it up over the pool.
1
as described in chapter "Connecting the water
7
5 .
4
and hang them on the pool.
and with a hand pump, inflate the
2 , attach a garden hose to the
3
, and the balls 8
Use
.
13