Important Safety Instructions - CountyLine CLPT20H Manual Del Usuario

Safety
Important Safety
Instructions
SAVE THESE INSTRUCTIONS - This manual
contains important instructions that should be
followed during installation, operation, and
maintenance of the product.
safety alert symbol. When you see this symbol
on your pump or in this manual, look for one of
the following signal words and be alert to the
potential for personal injury!
indicates a hazard which, if not
avoided, will result in death or serious injury.
indicates a hazard which, if not
avoided, could result in death or serious injury.
indicates a hazard which, if not
avoided, could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions
in this manual and on pump .
Keep safety labels in good condition. Replace
missing or damaged safety labels.
California Proposition 65 Warning
This product and related
accessories contain chemicals known to the
State of California to cause cancer, birth defects
or other reproductive harm.
1. Read this manual carefully. Failure to follow
2. Consult installer or licensed plumber for
This is the
3. Always test water from well for purity before
4. Before installing or servicing tank, BE SURE
5. Install relief valve in pump supply line to tank,
6. BE SURE pump electrical circuit is
7. Remove bleeder orifices, air volume controls
8. DO NOT USE tank as a surge suppressor.
possible serious or fatal injury and/or damage to
equipment, system pressure must be less than
100 pounds per square inch (PSI) (689kPa) under
any circumstances. Failure to follow instruction
can result in tank blowup. If system discharge
pressure can exceed 100 PSI (689kPa), install a
relief valve capable of passing the full pump
volume at 100 PSI (689kPa).
pump, tank, or piping system to freeze. Freezing
can severely damage equipment and may lead
to tank explosion and serious injury. Allowing
tank to freeze voids tank warranty.
these Instructions could cause serious bodily
injury and/or property damage.
correct relief valve. Install system according to
local codes.
using. Check local health department for
testing procedure.
pump electric power source is disconnected.
Release all water pressure before working on
tank or system. Release air pressure before
removing cover flange.
as close to tank as possible.
properly grounded.
or other air charging devices in existing system.
Risk of explosion . To prevent
Risk of freezing . Do not allow
2