ENERMAX Platimax Manual Del Usuario página 6

①


Set your PSU into the chassis, and please
make sure the
I/O switch is
on "O"
position.
③


Plug the AC
cord into your
PSU.
1. CordGuard is for AC cords supplied with ENERMAX CordGuard-compatible PSUs. Other AC
cords may be incompatible.
2. When assembling or maintaining the system, please remove AC cord from AC inlet, or turn I/O
switch into "O" position.
CABLES & CONNECTORS
All connectors are designed to prevent insertion in wrong orientation. If you cannot easily insert a
connector, please check if you are inserting the connector in the right orientation. Do not try by force to
insert it nor modify the connectors. This might damage power supply and system components, and
warranty shall be void.
Following graphic illustrates the modular sockets layout and its DC rail distribution.
＊ You must connect 16-pin and 20-pin connectors into respective sockets to enable 24-pin MB and
8-pin CPU connectors.
＊ This product incorporates multiple 12V rails over current protection. If you let many peripherals
consume the power on only one 12V rail, it may trigger the over current protection and shut down
the system. Please re-direct certain peripheral power cable to other 12V rail to share the current
loading to ensure highest stability and safety.
②


Press two sides of the CordGuard lock
together, and set it into
CordGuard holder near
the AC inlet.
④


Lock CordGuard to
latch onto AC cord.
4