Assembly Instructions - Konig & Meyer Omega-E 18800-000-55 Manual De Instrucciones

The following assembly steps must be followed:
Prior to assembly, determine whether the control panel will be
IMPORTANT
mounted on the right or the left! Depending on the choice of
sides, use the respective outer hole on the retaining plate for
fastening.
Ü
Ü
Ü
Please note: The columns have a relatively high dead weight
and therefore must be handled with care.
In the assembled state, the long side of the base plates must
IMPORTANT
be on the operator side.
The master column is marked "Master" on top and has more
sockets.
Table-style keyboard stand »Omega-E«
Item no.: 18800-000-55 / 18800-010-55
Mount the control panel on the transverse bar. To
do this, slide the washer onto the hexagon bolt à In-
sert the bolt through the retaining plate, bracket /
transverse bar à Push the washer onto the bolt à
Screw on the lock nut and tighten with the key included
à Place the protective caps.
Fasten the second side (up to the retaining plate) in the
same way.
A
Mount the base plates onto the master/slave col-
umn
To do this, place the column(s) on the upper part à
Place the base plate(s) and tighten with the Allen key
included (tightening torque max. 10 Nm) à Set down
columns after assembly.
Assembly
A
3
Assembly in-
structions
16