Playing Back Ipod - Sony CDX-H910UI Manual De Instrucciones

iPod
For details on the compatibility of your iPod, see
"About iPod" on page 21 or visit the support site.
In these Operating Instructions, "iPod" is used as
a general reference for the iPod functions on the
iPod and iPhone, unless otherwise specified by
the text or illustrations.
Support site
For customers in the U.S.A. and Canada:
http://esupport.sony.com
http://www.xplodsony.com/
For customers in Europe:
http://support.sony-europe.com
For customers in Latin America:
http://esupport.sony.com/ES/LA/
For customers in Pan Asia:
http://www.sony-asia.com/section/support
http://www.sony-asia.com/caraudio/

Playing back iPod

Before connecting the iPod, turn down the
volume of the unit.
1
Remove the USB cap from the USB
connector and connect the iPod to the
USB connector via the dock connector
to USB cable.
The iPod will turn on automatically, and the
display will appear on the iPod screen as
below.*
The tracks on the iPod start playing
automatically from the point last played.
If an iPod is already connected, to start
playback press (SOURCE) repeatedly until
"USB" appears. ("IPD" appears in the display
when iPod is recognized.)
* If the iPod was played back in the passenger control
last time, this will not appear.
2
Press (MODE) to select the play mode.
The mode changes as follows:
RESUMING t ALBUM t TRACK t
PODCAST* t GENRE t PLAYLIST
t ARTIST
* May not appear depending on iPod setting.
3
Adjust the volume.
Press (OFF) to stop playback.
Removing the iPod
1 Stop the iPod playback.
2 Remove the iPod.
Caution for iPhone
When you connect an iPhone via USB, telephone
volume is controlled by iPhone itself. In order to avoid
sudden loud sound after a call, do not increase the
volume on the unit during a telephone call.
Note
This unit cannot recognize iPod via a USB hub.
Tips
• We recommend the RC-100IP USB cable (not
supplied) to connect the dock connector.
• When the ignition key is turned to the ACC position,
and the unit is on, the iPod will be recharged.
• If the iPod is disconnected during playback, "NO
DEV" appears in the display of the unit.
Resume mode
When the iPod is connected to the dock
connector, the mode of this unit changes to
resume mode and playback starts in the mode set
by the iPod.
In resume mode, the following buttons do not
function.
– (3) (REP)
– (4) (SHUF)
15