Sears Kenmore 665.1361 Serie Manual De Uso Y Cuidado página 9

Trimless Panel with Handle
Dimensions
Use these dimensions drawings to create a custom panel for use
without a trim kit. The panel should be 1/2"to %" (13 mm to
16 mm) thick.
NOTE: A thicker panel may need rounded front corners and a
cutout for access to the handle.
2313/1_"
(60_5 ram)
_'_ (3&1 ram)
Installation
1. Remove the mounting screws attaching the foot pedal to the
compactor. Remove foot pedal.
6. Reinstall the toe guard using the existing mounting screws
and 1/2"washer. Then, reinstall the foot pedal.
B
D
E
F
A. Handle
B. Custom panel
C. Panelscrew locations
D. Toeguard
E. Washer
E Toeguard mounting screw
Trimless Panel without Handle
Dimensions
Use these dimension drawings to create a custom panel for use
without a trim kit. The panel should be 1/2"(13 mm) min, thick,
A. Mounting screws
B. Foot pedal
2. Remove mounting screws attaching the toe guard to the
compactor. Remove toe guard.
3. Remove the mounting screws attaching the decorative panel
to the compactor. Remove decorative panel and discard
mounting screws.
4. Align the top of the custom panel with the bottom of the
handle.
5. Secure the custom panel from the back using 4 - #8 x 1"
wood screws as shown,
15"
(38.1 cm)
25%"
(65.1 cm)