SETTING UP YOUR OVEN
Names of Oven Parts and Accessories
Remove the oven and all materials from the carton
and oven cavity.
Your oven comes with the following accessories:
A) Control panel
B) Turntable shaft
C) Turntable ring assembly
D) Glass tray
E) Observation window
F) Door assembly
G) Safety interlock system
TURNTABLE INSTALLATION
a. Never place the glass tray upside down. The glass
tray should never be restricted.
b. Both glass tray and turntable ring assembly must
Glass tray always be used during cooking.
c. All food and containers of food are always placed
on the glass tray for cooking.
d. If glass tray or turntable ring assembly cracks or
Turntable shaft breaks, contact your nearest
authorized service center.
Turntable ring assembly
COUNTERTOP INSTALLATION
Remove all packing material and accessories.
Examine the oven for any damage such as dents or
broken door. Do not install if oven is damaged.
Cabinet: Remove any protective film found on the
microwave oven cabinet surface.
INSTALLATION
Remove all packing material and accessories.
Examine the oven for any damage such as dents or
broken door. Do not install if oven is damaged.
1.Select a level surface that provide enough open
space for the intake and/or outlet vents.
(1) The minimum installation height is 85cm.
(2) The rear surface of appliance shall be placed
against a wall.
Leave a minimum clearance of 30cm above the oven,
a minimum clearance of 20cm is required between
the oven and any adjacent walls.
(3) Do not remove the legs from the bottom of the
oven.
(4) Blocking the intake and/ or outlet openings can
damage the oven.
(5) Place the oven as far away from radios and TV
as possible. Operation of microwave oven may cause
interference to your radio or TV reception.
2. Plug your oven into a standard household outlet.
Be sure the voltage and the frequency is the same
as the voltage and the frequency on the rating label.
WARNING: Do not install oven over a range cooktop
or other heat-producing appliance. If installed near
or over a heat source, the oven could be damaged
and the warranty would be void.
The accessible surface
may be hot during operation.