6. Insert batteries in the remote control
The remote control contains a CR2025 3V lithium battery.
The first time you use the remote control,
pull off the transparent film without open-
ing the battery compartment.
Replace the battery if the device fails to react to com-
mands from the remote control properly. Then follow
these steps:
Press down the locking tab (b) and pull the battery
holder with the battery (a) out from the remote con-
trol. Dispose of the old battery in accordance with
legal regulations.
Place a new CR2025-type 3V battery in the holder
(c), with the positive pole pointing upward. Check
the battery polarity is correct.
Slide the holder with the new battery completely
into the slot (d) in the remote control.
110
b
a
c
d