Kensington OfficeAssist A6000 130X Manual De Instrucciones página 4

English
OfficeAssist A6000 shredding capability
™
OfficeAssist A6000 CAN shred the following:
™
• 600 sheets
• Stapled paper, 25mm within the corner
• 26/6 and 24/6 or smaller staples
• Small sized paper loaded centrally
• 600 sheets
• Paper clip paper, 25mm within the corner
• Capable of shredding small/medium paper clips (max. wire thickness = 0.9 mm)
• >20 lb paper (through manual feed slot ONLY)
• A3 folded in half max. 2 sheets
• 600 sheets
• 20 lb paper
- Letter and Legal
- A3 single sheet folded in half to make A4
OfficeAssist A6000 CAN shred (through the manual feed slot):
™
Thick paper or
card.
Unopened mail
(e.g. junk mail).
OfficeAssist A6000 CANNOT shred the following:
™
Heavy duty
staples. Check
the staple leg
length is not
greater than
6mm.
Bulldog clips
Adhesive labels.
8
Multiple folded
sheets (e.g. A3
sheets folded in
half).
Glossy paper or
a sheet covered
with print on both
sides.
Large clips. Plastic sheets,
Check the length laminated
of the paperclip documents,
is not longer than plastic folders.
32mm.
Bound
documents
Magazines or
other documents
bound by multiple
staples or clips.
initial setup (1)
The shredder is designed to automatically lubricate the cutting mechanism as required to ensure
the product continues to work to its maximum performance and to extend the product life. Please
follow the operation instruction before turning on the shredder for the first time. The 60ml bottle
of oil* is sufficient to allow the shredder to start for the first time and to operate continuously for
about one hours shredding before the reservoir will need refilling. When the 'Oil Refill' indicator is
illuminated ( ), flip up the oil reservoir cap and refill the oil reservoir using a bottle of standard
GBC oil (1760049)*. The automatic oiling operation (
®
you will hear the distribution pump during this time. Auto-oiling operates after 15 minutes of
shredding time.
bin or loading door open safety function
As a safety precaution, if the bin or loading door is opened during shredding, the shredder will stop
and the bin full indicator will illuminate ( ).
intelligent help
1 In the unlikely event of the shredder jamming, the OfficeAssist
and the jam icon will blink in orange.
2 The shredder will illuminate the FWD (
to clear the jam.
3 If the jam cannot be intelligentally cleared, the jam icon (
open the auto feed chamber to clear any jammed material.
automatic jam clearance
Auto+ Jam Clearance: In the unlikely event of the shredder jamming, the OfficeAssist
®
automatically reverse and forward the engine three times to clear a jam. During this operation the
Paper Jam indicator will flash ( ).
self-cleaning cutters
After emptying and replacing a full bin, the shredder will run in forward for 4 seconds, stop for
2 seconds and then reverse for 4 seconds to clear away any remaining paper from the cutter
mechanism. This unique 'self-cleaning' mechanism is additional jam prevention technology
from Kensington.
* ACCO Brands accepts no liability for product performance or safety when other types or brands of lubricants are used on any
part(s) of this machine.
) last approximately two seconds and
A6000 will stop shredding,
™
) and REV ( ) buttons in the sequence necessary
) will illuminate in red. At this point
A6000 will
™
A 6 0 0 0 S H R E D D E R S
O F F I C E A S S I S T
™
English
9