On Cleaning; Specifications - Sony AN-01 Manual De Instrucciones

- near air conditioning equipment or
places subject to direct air flow from
an air conditioner
- near public address loudspeakers
- where adjacent equipment might
knock against the tuner
- Keep this unit as far from such
equipment as possible or use buffering
material.

On Cleaning

• If this unit is used in a very humid or
dusty place or in a place subject to an
active gas, clean its surface as well as the
connectors with a dry, soft cloth soon
after use. Lengthy use of this unit in such
places or not cleaning it after its use in
such places may shorten its life.
• Clean the surface and the connectors of
this unit with a dry, soft cloth. Never use
thinner, benzene, alcohol or any other
chemicals, since these may mar the
finish.
For more information on connections of
this unit, refer to the Operating
Instructions supplied with the connected
device (tuner, tuner base unit, or antenna
divider, etc.).
24

Specifications

Specifications
Antenna section
Frequency range
470 to 862 MHz
Antenna gain
5 dBi or more
Voltage standing wave ratio
2.5 or less
Half power angle
150 degrees or less
Front to back ratio
12 dB or more
Booster section
Frequency range
470 to 862 MHz
Booster gain
18 dB/10 dB/0 dB, switchable
Output impedance
50 ohms
Voltage standing wave ratio
3 or less
Noise figure
6 dB or less
Third order intermodulation
60 dB or more (95 dBµV
Output connector
BNC-R type
Supply voltage
9 V/12 V DC
Current consumption
100 mA or less
General
Operation temperature
0 °C to 50 °C (32 °F to 122 °F)
Storage temperature
–20 °C to +60 °C (–4 °F to
+140 °F)
input)
EMF