InWin AURORA Manual Del Usuario página 3

Components
1. Aurora fans x 3
2. User manual x 1
3. Controller x 1
4. Screws x 12
5. Power wire
6. LED light strip 30cm x 2
7. 6-6 pin short connecting wire (connect fan to fan) x 2
Installation
1. Please make sure the power is off.
2. Install the fans in your PC case, and screw it in the designated areas.
3. Use power wire to connect the controller and the power.
4
5
3 6
4.
Use 4-4 pin connecting wire to connect the controller and the motherboard.
5.
Use USB-4 pin connecting wire to connect the controller and the motherboard.
6.
Use 6-6 pin long connecting wire to connect the controller and the IN
part of the first fan.
Motherboard
IN
6
!
When you are connecting the 6-6 pin short
connecting wire to the fan, please make
!
sure you insert the extended locking clip of
the 6-6 pin short connecting wire to the
corresponding opening of the fan.
8. 6-6 pin medium length connecting wire (connect fan to fan) x 1
9. 6-6 pin long connecting wire (connect fan to fan) x 1
<Retail Package Only>
10. 6-3 pin long connecting wire (connect fan to LED) x 1
11. 3-3 pin long connecting wire (connect LED to LED) x 1
12. 4-4 pin connecting wire x 1
13. USB-4 pin connecting wire x 1
7. Use 6-6 pin short connecting wire to connect the OUT part of the
first fan and the IN part of the second fan.
8. Use 6-6 pin short connecting wire to connect the OUT part of the
second fan and the IN part of the third fan.
9. Use 6-3 pin connecting wire to connect the OUT part of the third
fan and the LED strip.
7
OUT IN
AURORA fans can be connected to each other through the 6-6pin
connecting wires, hence the installation above is a suggestion.
9
6-3 pin
10. LED strips can be connected to each other directly or be connected
through 3-3 pin connecting wire
11. RGB lighting effect can be controlled through our exclusive software.
Please download the software at
(https://www.inwin-style.com/en/fans/aurora)
or scan the (QR code).
8
OUT IN OUT
9
3-3 pin
.
P2
P3
10