Rear Panel - Yamaha GC2020C Manual Del Propietário

C
OUTPUT control
This controls the output level. When the input signal is
compressed by the compressor/limiter, it may appear to
have diminished in volume. This knob adjusts the level of
the signal that has been processed by the compressor/lim-
iter. While turning the COMP switch ON/OFF, adjust the
OUTPUT control so that the volume of the bypassed and
processed signals is the same.

Rear Panel

D
OUTPUT jacks
These are the output jacks. Three-pin XLR type connectors
(male) and 1/4" phone jacks are provided. Both types are
balanced. Nominal impedance is 600 ohms for both.
E
INPUT jacks
These are the input jacks. Three-pin XLR type connectors
(female) and 1/4" phone jacks are provided. Both types are
balanced. Nominal impedance is 600 ohms for both.
F
SIDE CHAIN INT/EXT switch
This switch selects the signal source for the circuit that
detects the point at which the compressor/limiter is applied.
With a setting of INT, the detector uses the channel signal.
With a setting of EXT, the detector uses the signal from the
SIDE CHAIN IN jack.
G
SIDE CHAIN IN/OUT jack
These jacks are used to split the input signal, or to use an
external signal as the trigger for the compressor/limiter.
CHANNEL B
OUTPUT INPUT
SIDECHAIN
+4dB +4dB
KEY
INT EXT
D E F
CHANNEL A
OUTPUT INPUT
+4dB +4dB
IN OUT
G
Rear Panel
SIDECHAIN
IN OUT
KEY
INT EXT
GC2020C Compressor/Limiter Owner's Manual
7