Selecting Tracks For Recording; Checking The Version Number; Updating The System Software - Yamaha RC-D24 Manual De Instrucciones

9

Selecting Tracks for Recording

Selecting Tracks for Recording
The RC-D24 does not have dedicated RECORD READY buttons like the D24. Instead
tracks are selected for recording using the [REC] button and keypad buttons [1]
through [8].
While holding down the [REC] button, use keypad buttons [1] through [8] to
1
select tracks for recording.
When a track is selected for recording, a small circle appears above the corresponding
track number, as shown below, and the corresponding READY indicator flashes on the
D24. The Unit Select setting is displayed on the RC-D24 while the [REC] button is
pressed, as shown below.
All tracks can be selected for recording by pressing the [0] button while holding down
the [REC] button, and all tracks can deselected by pressing the [9] button while holding
down the [REC] button.
Release the [REC] button when you've selected tracks for recording.
2
The Unit Select setting can be changed simply by pressing the [UNIT SELECT] button
while holding down the [REC] button, allowing you to select tracks on other D24s.
Recording is started in the normal way, see the D24 Owner's Manual for more informa-
tion.

Checking the Version Number

You can check the version number of the RC-D24 system software as follows.
Turn off the RC-D24.
1
While holding down the [RTN TO ZERO] button, turn on the RC-D24.
2
The version number appears on the display.

Updating the System Software

See the Yamaha Professional Audio Web site at the address below for information on
system updates.
<http://www.yamaha.co.jp/product/proaudio/homeenglish/>
RC-D24—Owner's Manual
ms
REMOTE CONTROLLER/LOCATOR
H M
0 0 0 0 0 0 0 0
H
1
READY UNIT 1
Current Unit
Select setting
S F
M S F ms
2 3 4 5 6 7 8
Tracks selected
for recording