Hartan Racer GT Serie Manual De Instrucciones página 11

Instructions
Climatic zone 18
To provide good ventilation to the hood and to prevent heat from
accumulating inside, open the two zip fasteners 23 and fold up the hood
flap. Use the Velcro band below the additional tap to secure the flap to
the hood. As an additional protection, the sun visor 21 can be pulled out.
WARNING!
Safety belt
Secure your child with the five­point harness system 14.
Make sure the shoulder straps D are plugged in and that the belt is
securely fastened. The length of the belt can be adjusted with sliding
buckle F, the length of the crotch strap G can be adjusted with quick­
release slider H.
To undo the harness: press the two tongues B together using your
thumb and forefinger, then press the red button A, so that you can pull
the two plugs E out upwards. To undo the shoulder straps you then
press button C.
Canopy attachment 22
Insert then the fixing peg of the canopy in the slot of the
canopy attachment.
Adjusting the footrest
By pressing the two red safety buttons 15 at the same time, the footrest
can be lowered. When lifting it, adjustment of positions is effected
automatically. The footrest can be lengthened. To do this, pull the two
red pins 16 and turn the footrest by 180°.
WARNING!
In case the carrycot is attached to the frame, the
footrest should always be in horizontal position, as an additional
protection preventing it from slipping out. Secure the carrycot according
to the operating instructions.
Automatic attachment locking
Place the seat unit on the frame in such a way that both locking handles
are sitting on top of the support studs. The latches on both sides lock
automatically as soon as you let go of the handles.
WARNING!
Check before use that the seat unit is securely
fixed! To open the lock, pull the red knob out slightly, then the seat
unit can be removed. The seat unit can also be turned round.
Adjusting the backrest
By raising adjustment lever 13 on the back, the seat­back can be
precisely adjusted to any incline between an upright seated position and
a lying position.
WARNING!
When adjusting the backrest, take care that no movable
parts jam the baby's limbs, or fingers, etc. Finally, make sure the backrest
has reengaged properly.
Protection from falling out
WARNING!
As additional protection against falling out, fix the press­buttons 17 of
the hood to the metal frame of the backrest.
10
23
F
14
C
A
B
17
13
18
D
E
F
G
H
17