Installation
STEP 7 Connect the water dispenser line
A water dispenser with a filter is one of the helpful features on your new refrigerator. To
help promote better health, the water filter removes unwanted particles from your water.
However, it does not sterilize or destroy microorganisms. You may need to purchase a
water purifying system to do that.
The water line also connects to the ice maker. For the ice maker to operate properly,
water pressure of 20-125 psi is required.
If the refrigerator is installed in an area with low water pressure (below 20 psi), you can
install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the
refrigerator is properly filled. To do this, press the water dispenser lever until water runs
from the water outlet.
NOTE
• Water line installation kits are available at extra cost from your retailer. We
recommend using a water line installation kit that contains copper tubing and a
(6 mm) compression nut.
A
B
C
B
36
English
Untitled-3 36
1. Shut off the main water source.
2. Insert the pipe clamp (B) and the
3. Connect the water line installation kit
A
shutoff valve (C) into the cold water
line (A).
(A) to the shutoff valve (B).
/
"
1
4
2019-06-13
11:17:37