GARDENIQUE Sedona Instrucciones De Uso página 5

STEP 3 - BACKFILL
Backfill around basin, keeping basin lid free
from debris.
STEP 4 - PLACE TOPPER
Run tubing and light cord of decorative
topper through center hole of basin lid.
Place the fountain topper in the middle of
basin lid.
STEP 5 - ATTACH THE PUMP
Remove side access panel of basin lid and
connect tubing and light cord from inside
the fountain topper to pump.
Run pump power cord through side access
panel hole, reattach side access panel.
STEP 6 - FILL THE BASIN AND TEST
Fill the basin with water then install the
lid. To ensure the pump flow control is set
appropriately and the water is flowing back
into the basin, place the fountain unit in its
final location adjusting as needed using the
pad sheets, and plug in the pump. Check for
leaks and adjust accordingly, then backfill
the hole with dirt.
STEP 7 - ADD ROCKS AND PLANTS
(NOT INCLUDED)
Wash decorative gravel to remove small
debris.
Decorate top of the basin with decorative
gravel, plug in the pump, and enjoy!
3
VISIT WWW.GARDENIQUEDECOR.COM FOR PRODUCT INFORMATION AND TIPS.