Section 2. Set Up; Front Display Panel - TECshow FLATSIX Manual De Usuario

Section 2. Set Up

• Installation
• Controlling Board
• Machine Connection
Installation
This machine should be mounted through the screw holes of
truss. Safety wire is a must to fix fixture well. Make sure truss
and safety wire have strong load capacity to bear 3 times
weight than fixture at least. This machine should be installed
by qualified technician.
Controlling Board

Front display panel

FLATSIX - LED PAR LIGhT
ENGLISH VERSION
1. Display
Display menu and selected function.
2. Button
MENU switch menu function
On function: page up
UP
On numerical value: increase value
On function: page down
DOWN
On numerical value: reduce value
ENTER Settle selected function and value
3. DMX signal input
Control model by DMX signal: please use 3pin XLR signal cable.
4. DMX Signal output
Transfer DMX signal to next model, please use 3pin XLR
signal cable.
5. Power output
Connect to obtain power (attention: please use connect to
stated voltage.)
6. Power input
Connect to obtain power
p. 5