Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
AFTEREACHUSE
Water should not remain in the unit for long periods of time.
Sediments or minerals can deposit on pump parts and
"freeze" pump action. Follow these procedures after every
use:
1.
Flush detergent system by turning its detergent shut-off
valve to "Off" position and run pressure washer with
PrecisionSpray
TM
Selector in a low pressure position.
Flush for one to two minutes.
2.
Shut off engine, turn off water supply, point gun in a
safe direction, press red button and squeezetrigger to
relieve trapped pressure and let engine cool.
_i, WARNING:The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYSpointspraygun in safedirection,pressred button
andsqueeze sprayguntriggerto release highpressure, e very
time you stop engine.
3.
Disconnect hose from spray gun and high pressure
outlet on pump. Drain water from hose, gun, and spray
tip extension. Use a rag to wipe off the hose.
4.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most liquid in
pump.
5.
Coil high pressure hose on hook provided on handle.
6.
Store unit in a clean, dry area.
7.
If storing for more than 30 days see Long Term Storage
on next page.
_i, WARNING:Fueland its vapors are extremely
flammable and explosive.
Fire or explosion can cause severe burns
or death.
WHENSTORING FUELOREQUIPMENT WITH FUELIN TANK
• Storeawayfrom furnaces,stoves,waterheaters,clothes
dryers,or otherappliances that havepilot light or other
ignitionsourcebecause they can ignitefuel vapors.
2O
Publicidad
Tabla de contenido
