Pressurewasher Location - Craftsman 580.752530 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HOWTO USEYOURPRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
PressureWasher Location
PressureWasher Clearance
_k WARNING Exhaust heat/gases can ignite
combustibles, structures or damagefuel tank
causing a fire.
• Keepat least 5 ft. (152 cm) clearanceon all sides of pressure
washer including overhead.
Place pressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when positioning
_ressure washer.
_k WARNING Running engine gives off carbon
monoxide, an odorless, colorless, poisonous gas.
_
Breathing
can cause headache,
carbon monoxide
fatigue, dizziness,vomiting, confusion, seizures,
nausea, fainting or death.
• Operate pressure washerONLYoutdoors.
• Keepexhaust g asfrom enteringa confined areathrough
windows,doors,ventilationintakes, o r otheropenings.
• DONOT startor run engineindoorsor in an enclosed area,
evenif windowsanddoorsareopen.
To Start Your Pressure Washer
To start your engine-powered pressure washer for the first
time, follow these instructions step-by-step. This information
also applies whenever you start the engine after you have let
the pressure washer sit idle for at least a day.
1.
Place pressure washer outside near an water source
capableof supplying water at a flow rate greater than
3.7 gallons per minute and no less than 20 PSi at
pressure washer end of garden hose.
2.
Checkthat high pressure hose is tightly connected to
spray gun and pump. See Assembly for illustrations.
3.
Make sure unit is in a level position.
4.
Connectgarden hose to water inlet on pressure washer
pump.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment r esulting from failureto followthis
instruction will voidwarranty.
5.
Turn ONthe water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
6.
Attach nozzleextension to spray gun. Tighten by hand.
|l ml I|
.
Pull back on collar of nozzle extension, insert selector
nozzle and releasecollar. Tug on selector nozzle to make
sure it is securely in place. See How to Use Selector
Nozzle.
8.
Push engine rocker switch (B) to on position (I or ON).
\
11

Publicidad

Tabla de contenido
loading

Tabla de contenido