Craftsman 580.754880 Instrucciones De Uso página 11

Connect Hose and Water Supply to Pump
NOTICE DO NOT run the pump without the water
supply connected and turned on.
o Damage to equipment resulting from failure to follow this
instruction will void warranty.
4. Run water through garden hose for 30 seconds to
flush it of debris. Turn off water.
NOTICE DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in
length) to water inlet. Tighten by hand.
NOTICE Remove and discard the shipping caps from
the pump's high pressure outlet and water inlet before
attaching hoses.
1. Uncoil high pressure hose and attach one end of
hose to base of spray gun. Tighten by hand.
WARNING The high pressure stream of water
1_ that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
NEVER connect high pressure hose to nozzle extension.
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
Always be certain spray gun. nozzles and accessofles
are correctly attached.
2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
3. Before connecting garden hose to water inlet,
inspect inlet screen (A). Clean screen if it contains
debris or have it replaced if damaged. DO NOT run
pressure washer if inlet screen is damaged or
missing.
NOTICE Using a One Way Valve (vacuum breaker
or check valve) at pump inlet could cause pump or
inlet connector damage.
There MUST be at least ten feet of unrestricted garden
hose between the pressure washer inlet and any device,
such as a vacuum breaker or check vatve.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
_, WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using
or in vicinity of this equipment.
NEVER substitute safety gtasses or dry-condition goggles
for indirect vented safety goggtes.
6 Turn ON the water, press red button (B) on the gun
and squeeze the trigger to purge the pump system
of air and impurities,
Checklist Before Starting Engine
Review the unit to ensure you have performed all of the
following:
1 Be sure to read Safety Rules and Operation
sections before using the pressure washer.
2. Make sure handle is in place and secure.
3. Check that oil has been added to proper level in
engine crankcase.
4. Add proper fuel to fuel tank.
5. Check for proper hose connections (high pressure
and water supply) and that there are no kinks, cuts,
or damage to the high pressure hose.
6. Provide proper water supply (not to exceed 100°F).
11