Audio Pro RADIO ONE Manual Del Propietário página 14

OpeRaTiOns
RadiO One
R-10 & R-20BT
1. TO LisTEn TO radiO
make sure the rear power switch is set to On.
push On/sTandBy on front panel to put Radio One in On mode.
auto search:
push 1 sec on << or >> button to start auTO search. The search is automatically stopped
as soon as an Fm station is received. push short again to search another Fm station.
manual search:
push << or >> button and hold to start manual search.
hold the button pushed until a desired frequency is found.
- Fine tune by short push -/+ 0.05 mhz
sTORe sTaTiOns TO pReseT memORy
Tune in a desired station. push the preset button for 3 seconds. mem seT is displayed in
the display window. Turn the volume knob or << or >> to select the preset number to be
stored. press the preset button again to store into the preset memory.
The preset function allows 6 Fm stations to be preset in the preset memory.
TO seleCT a pReseT sTaTiOn FROm The memORy
push short on the preset button, mem Call is displayed in the display window.
Turn the volume knob or << or >> to select the desired preset number.
2. TO sET THE aLarm TimE and aCTiVaTE On mOdE
make sure the correct clock time is set (see to set the clock).
3. TO inPUT a dEsirEd aLarm On TimE
push the volume control to enter alarm mode. in alarm mode turn the volume knob to enter
alarm On. push again to enter On time. Turn the volume knob to select desired hour (00-
23). push again and adjust minutes (00-59) by turning the volume knob. Then push again
and turn to select Fm radio or Beep as wakeup call. in case of Fm push for next setting,
preferred preset station. Then press again and turn to select volume of alarm. push again
to confirm settings.
The alarm is now set.
press source to leave menu mode.
when alarm is set to On, a small Clock indicator (C on previous page) is shown in the
display.
during a wakeup call (Fm or Beep) snooze can be activated by pressing any button.
snooze time is 5 minutes and can be repeated. during snooze the time length can be
changed using << or >> buttons (adjustable 1 – 20 minutes). default time is always 5
minutes. The snooze function works up to one hour after alarm start.
push the alaRm button twice to cancel snooze and turn off the alarm.
if the alarm time remains unchanged for next day, just activate the alarm by pressing the
alarm button. alarm On and the clock indicator is displayed.
alarm settings can only be changed in the alarm menu mode.