Doortec CarTeck 20.1 Instrucciones De Montaje página 27

Adjustment for the antenna
as shown in the picture.
The maximum number of
channels that can be saved is 16.
1
Programming the 1st channel to run the operator:
3
Programming of the 2nd channel for light on/off.
5
The programming procedure terminates automatically after 10 secs. if no
other channel programming begins.
6
To delete all programmed channels.
7
Checking of programmed functions.
Subject to technical modifications without prior notice.
Press TF for approximately 5 seconds until red LED lights.
2
1.
1.
2.
2.
3.
4.
Press TL for approximately 5 seconds until red LED lights.
Press TL one more time briefly,
red LED blinks every 2 seconds.
4
1.
1.
2.
2.
3.
4.
Press TF for approximately 5seconds until red LED lights.
Now press it again, briefly release, and press and hold
until red LED blinks rapidly. After release red LED will
blink every 5 seconds.
LED red
1.
1.
2.
2.
3.
4.
LED green
Instruction manual for receptor 868Mhz. 27
Press the selected channel of the
hand-held transmitter. Red LED confirms
by flashing.
Wait about 10 seconds until
red LED turns off.
Press the selected channel
of the hand-held transmitter, (not the same
one as the 1st programmed channel).
Red LED confirms by flashing rapidly.
Press the selected channel of the
hand-held transmitter to confirm the function
of the garage door, LED green lights briefly.
Press the next selected channel of the
transmitter to confirm the function light
on/off, red LED lights briefly.
TP-20. 1 u. 30. 1 -07/13