Gg Knob (With Bolt); Screw - Twinstar Home 26MM4995 Instrucción De Montaje

8. Insert Wood Dowels (CC) into the pre-drilled holes
on the Left/Right Side Panels (E,F). Locate Top
Panel (G) and lay fi nished side up on top of
completed assembly, using Bolts (DD) through the
pre-drilled holes in the Top Panel (G) and tighten.
Hardware Used
Wood Dowel
CC
DD Bolt
9. Locate Right Front Door (M) and Left Front Door
(L). Slide door hinge keyhole into panel hinge
bracket. (Diagram 1)
Use Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change keyhole
slot position. (As Shown In Diagram 2a)
To adjust door right or left loosen/tighten screw.
(As Shown In Diagram 2b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 2c)
Attach the Knob (GG) to the Left Front Door (L) and
Right Front Door (M), use the bolts attached through
the pre-drilled holes in the doors. Then use a Phillips
Head Screwdriver to tighten the bolts.
Hardware Used
GG
Knob
10. Attach Side Back Panels (I) and Center Back Panel
(J) to the back of the completed assembly from
step 8. Use a Phillips Head Screw Driver, tighten
Wood Screws (FF) through the pre-drilled holes
in the Side Back Panels (I).
Hardware Used
FF

Screw

Fig. 8
x 4
CC
x 4
Fig. 9
x 2
Fig. 10
x 32
7
DD
G
M
L
FF
J
I
CC
GG
I