Installing The Shoulder Strap - Huskie Tools HTP-RTH Manual De Instrucciones

(3) Battery low warning lamp
Off
(normal
operation)
Excessive (complete) discharging of
lithium ion batteries shortens their
service life dramatically. The driver
includes a battery protection feature
designed to prevent excessive dis-
charging of the battery pack.
• The battery protection feature ac-
tivates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
• If you notice the battery low warning
lamp flashing, charge the battery
pack immediately.
• If it is started with too little battery
power remaining, the tool may stop
operating without the battery low
warning lamp flashing first. This in-
dicates that there is too little bat-
tery power remaining to use the
tool, and the battery pack should be
charged before further use.
• If the tool is subject to a sudden
load during use that causes the mo-
tor to lock up, the overdischarge
prevention sensor may be triggered,
and the battery low warning lamp
may flash. The lamp will stop flash-
ing once you address the cause of
the motor's locking up and cycle the
trigger.
• The battery protection feature may
activate when a high load is abrupt-
ly placed on the motor, even if am-
ple battery charge remains. In this
case, both the battery low warn-ing
lamp and LED light will flash. (HTP-
RH)
Flashing
(No charge)
Battery protection
feature active
• If both the battery low warning lamp
and LED light flash, reduce the
force with which you are pushing
on the driver or, if using a drill driv-
er, adjust the speed switch to a low-
er setting. (HTP-RH)

Installing the Shoulder Strap

CAUTION:
• Install the shoulder strap firmly to
the main unit of the tool and check
the length of the strap before use.
• Check the condition of the strap
and do not use if it is cut or torn
etc.
There is a risk of injury or damage
if used while improperly installed.
• Please wear the shoulder strap se-
curely on the shoulder.
There is a risk of injury or damage
if it is accidentally dropped.
1. Pass the strap through the strap
holders. ( )
2. Pass the strap through the buckles
and adjust the length. ( )
Shoulder pad
• T h e s h o u l d e r s t r a p c a n b e
a d j u s t e d a c c o r d i n g t o t h e
individual.
• Adjust the shoulder pad to the
shoulder.
• Pull the shoulder strap to make
sure it is firmly attached to the main
unit of the tool.