Features; Mechanical Hazards; Operation Instructions - Urrea CCO820 Manual De Usuario

• ALWAYS check the machine for loosened
threads or bolts before starting.
• ALWAYS be sure the operator is familiar with
proper safety precautions and operations tech-
niques before using cutter.
• ALWAYS store equipment properly when it is
not being used. Equipment should be stored in
a clean, dry location out of the reach of chil-
dren.
• DO NOT operate this equipment unless all
guards and safety devices are attached and in
place.
• Keep all inexperienced and unauthorized
people away from the equipment at all times.
• Unauthorized equipment modifications will
void all warranties.
• NEVER pour or spray water over the engine.
• Test the engine ON/OFF switch before operat-
ing. The purpose of this switch is to shut down
the engine of the cutter.
• Refer to the Engine User's Manual for engine
technical questions or information recom-
mended for the equipment.
HAZARDS AND RISKS
· NEVER allow any person to operate the ma-
chine without adequate instruction.
· ENSURE all operators read, understand and
follow the operating instructions;
· SERIOUS INJURY could result from improper
or careless use of this machine;
Plates compactors are heavy units and should
be positioned by two people of appropriate
strength. Using
· The lifting handles provided on the machine,
along with correct lifting techniques.

MECHANICAL HAZARDS

· DO NOT operate the machine unless all pro-
tective guards are in place.
· KEEP handles and feet clear of rotating and
moving parts as they will cause injury if con-
tacted.
· ENSURE that the motor operation switch is
in the OFF position and the spark plug igni-
tion lead is disconnected before removing the
guards or making adjustments.
· ENSURE both the machine and the operator
are stable by setting up on level terrain and the
machine will not tip over, slide of fall while in
operation or unattended.
E N G L I S H •

FEATURES

This concrete cutter has been specifically
designed as the ideal machine for the profes-
sional contractor who is engaged in concrete
and asphalt flat sawing.
The machines used for the primary purpose of
"flat" sawing. This type of sawing is described
as "flat" because the pavement is cut some-
where close to a horizontal plane. It is the most
common type of diamond blade cutting.
It is possible to cut both concrete (green or
cured, with or without rebar) or asphalt with
a concrete cutter. This machine is utilized for
jobs requiring precision cutting including
floors, pavements, walkways, ramps and other
flat sawing applications.
You will find a cutter to fit a wide variety of
job applications
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
4
3
1-2. TRANSPORTATION WHEELS.
3. GUIDE.
4. CUTTING DISC GUARD.
5. DEPTH HANDLE.
6. HANDLES.

OPERATION INSTRUCTIONS

BEFORE OPERATION
PRE START-UP INSPECTION
The following Pre-start-up inspection must be
performed before the start of each work ses-
sion or after every four hours of use.
U se r's m a nu a l
5
6
1
2
11